
Drivers should reduce speeds, obey posted signs and allow additional travel time through active construction zones.
Source: N.M. Department of Transportation
Photos: Courtesy
A scheduled White Sands Missile Range roadblock will interrupt traffic on US 70 Monday morning, while construction continues along I-25, McNutt Road and several highways throughout southern New Mexico.
Motorists traveling toward El Paso will also encounter multiple construction zones, including a 51-hour eastbound I-10 closure scheduled for the coming weekend and a continuous closure of a U-turn underpass between Anthony and Vinton.
ATTENTION TRUCKERS: Trucks are currently prohibited from using NM 26 to access I-10 or I-25. Please plan an alternate route. Paving operations have officially started along NM 26 and Franklin Street in Hatch. Motorists traveling through the area should plan ahead and expect delays, lane closures and temporary business access restrictions as crews work to complete this project. Weather permitting, the project is expected to be completed by December 4. (Photos Courtesy NMDOT via Facebook)
Closer to Las Cruces, lane restrictions remain in place around Spruce Avenue and Triviz Drive, and new maintenance projects are affecting roads in the Hatch and Salem areas.
Drivers should reduce speeds, obey posted signs and allow additional travel time through active construction zones.
Monday Morning: US 70 Closure
White Sands Missile Range has scheduled a US 70 roadblock for Monday, Nov. 16, beginning at 6:20 a.m.
The closure is expected to last approximately one hour, with traffic restrictions lifting around 7:20 a.m.
The roadblock will affect two locations:
- Blue Block: Approximately two miles east of the WSMR access road, near mile marker 172.
- Yellow Block: Near White Sands National Park, at mile marker 200.
San Augustin Pass and the Las Cruces Gate will not be affected, but Nike Avenue will be affected.
The schedule is subject to change without notice. For updates, motorists can contact White Sands Missile Range at 575-678-1178 or 575-678-2222.
Las Cruces
Spruce, Telshor and Triviz
Lane closures continue around the Spruce Avenue, Telshor Boulevard and Triviz Drive intersection area.
Closures affect:
- Northbound Triviz Drive, between Spruce Avenue and Redwood Street.
- Westbound Spruce Avenue, between Telshor Boulevard and Wingate Road.
The roadway and intersection improvements are expected to continue through approximately Friday, Nov. 20.
Citywide Street Resurfacing
NMDOT’s latest report continues to carry a citywide micro-surfacing notice originally scheduled from Oct. 30 through Nov. 10.
The notice describes daytime street closures for resurfacing, but does not identify additional streets or provide an updated completion date.
Drivers should follow any remaining posted restrictions.
I-25: Las Cruces to Doña Ana
Guardrail replacement and concrete barrier construction continue along I-25 between mile markers 6 and 14.2, from Las Cruces to just north of Doña Ana.
Lane closures and traffic controls remain in place 24 hours a day in both directions while crews remove and replace guardrails and install concrete barriers.
Speed limits are reduced through the construction zone.
Contractor working hours are 6 a.m. to 5 p.m. Monday through Friday.
Receive the latest stories in your inbox every day — FREE!
Sunland Park and Santa Teresa
McNutt Road Construction Resumes
Road rehabilitation has resumed along NM 273/McNutt Road, following a suspension of work earlier this fall.
NMDOT reports construction affecting both northbound and southbound lanes between the Texas state line and approximately one mile south of Santa Teresa.
Speed limits will be reduced throughout the project.
Contractor working hours are 6 a.m. to 6 p.m. Monday through Friday.
Chaparral: NM 213 and NM 404
Major reconstruction continues along NM 213 and NM 404, with temporary traffic configurations in place for the first phase of construction.
On NM 404, traffic has been shifted toward the inside lanes in both directions for approximately one mile west of the roundabout. NMDOT expects this configuration to remain in place for approximately three more months.
On NM 213, traffic has been shifted east while crews work in the southbound lanes and shoulders to install temporary concrete barriers.
One lane remains open in each direction as crews install fencing, guardrails, drainage boxes and cattle guards, and prepare for bridge replacement and retaining-wall construction.
Temporary flagging and mobile traffic controls may also be used.
The speed limit is reduced to 45 mph throughout the construction zone.
Regular work hours are 6 a.m. to 6 p.m. Monday through Friday, with possible extended hours and weekend work.
Anthony: NM 460
Micro-surfacing work along NM 460 near Anthony has been completed.
NMDOT reports that pavement markings remain to be installed, with the work scheduled as soon as possible.
Hatch and Salem
I-25 Near Hatch
Lane closures continue along I-25 between mile markers 40 and 42, affecting the northbound and southbound passing lanes.
Crews are performing median repairs.
The speed limit is reduced to 55 mph through the work zone, with closures scheduled 7 a.m. to 5 p.m. Monday through Friday.
NM 26: Franklin Street to I-25
Roadway rehabilitation continues along NM 26 between Franklin Street and I-25 in Hatch.
Lane closures affect both directions in four-lane sections, while flaggers direct traffic through two-lane sections.
Work is scheduled 6 a.m. to 6 p.m. Monday through Friday, weather permitting.
NMDOT continues to list an expected completion date of mid-November.
NM 187: Hatch to Salem
Crack-sealing work is underway along NM 187 between mile markers 1 and 6, affecting both northbound and southbound traffic.
Flaggers will direct vehicles through the work zone, and motorists should anticipate delays.
Lane closures are scheduled 8 a.m. to 3 p.m. Monday through Thursday.
The project is expected to continue through late December.
NM 189: Utility Installation
Utility installation is scheduled along NM 189, with work described by NMDOT as extending from Vado toward NM 28 and crossing the intersection at NM 478.
Flaggers will control traffic, with expected delays of approximately 15 minutes.
Work is scheduled 8 a.m. to 4 p.m. Monday through Friday, with completion expected by Dec. 28.
NM 26: Deming to Hatch
Separate pavement-preservation work continues along NM 26 from mile marker 10 toward mile marker 46 near Hatch.
Drivers should expect daytime lane closures and pilot-car operations in both directions while crews perform crack sealing, fog sealing and install centerline rumble strips.
A temporary traffic signal will be used during daytime operations.
Work is scheduled 6:30 a.m. to 7 p.m. Monday through Friday, with possible weekend work.
The rumble strips are part of NMDOT's Target Zero initiative to help reduce head-on and crossover crashes.
I-10 Near Deming
Crack-sealing work continues along I-10 between exits 85 and 116, with crews working eastward from exit 85.
Lane closures will be used as needed in both directions, with reduced speed limits through active construction zones.
Work is scheduled 7 a.m. to 6 p.m., seven days a week.
Luna County
NMDOT crews are awaiting final pavement striping following chip-seal work on:
- Various I-10 frontage roads in the Akela area.
- NM 418, mileposts 10–12, along Old Lordsburg Highway.
Centerline striping may remain absent until work is completed.
I-25 Near Truth or Consequences
Road reconstruction along I-25 between mile markers 75 and 85, from Williamsburg to Cuchillo, is entering its final stages.
NMDOT reports that crews are completing striping and installing rumble strips.
Lane closures will occur as needed, and drivers should expect reduced speed limits.
Work is scheduled 6 a.m. to 6 p.m. Monday through Friday.
Traveling to El Paso
I-10: Anthony to Vinton U-Turn Closure
A continuous closure is scheduled through Saturday, Nov. 21, affecting the U-turn underpass at Bridge C between Anthony and Vinton.
Crews are demolishing and reconstructing the U-turn facilities beneath I-10.
Drivers on North Desert Boulevard will need to continue to Anthony, Texas, to use a U-turn bridge.
Drivers on South Desert Boulevard will need to continue to Vinton, Texas, to use a U-turn bridge.
I-10 and Desert Boulevards: Anthony to Mesa
From Monday, Nov. 16, through Saturday, Nov. 21, alternating lane closures may occur on:
- I-10 eastbound and westbound, between Anthony and Mesa.
- North Desert and South Desert boulevards, between Anthony and Mesa.
Closures are scheduled as needed between 9 a.m. and 4 p.m., and 9 p.m. and 6 a.m.
Crews will perform earthwork and miscellaneous removals. No detours are expected for these alternating closures.
Continuous South Desert and North Desert Restrictions
Additional continuous lane closures are in place at several locations:
- South Desert Boulevard: Left-lane closures between Valley Chile Road and Vinton Steel, and between Vinton and Logwood, for retaining-wall construction.
- South Desert Boulevard: Left-lane closure from Transmountain to Isela Rubalcava Boulevard for lane reconfiguration.
- North and South Desert boulevards: Left-lane closures at Los Mochis Drive for intersection construction.
- North Desert Boulevard: Left-lane closure between David and Nashua, associated with intersection construction.
TxDOT also lists a westbound I-10 exit-ramp closure with the David-to-Nashua work, but does not identify the affected exit ramp in its notice.
Artcraft Road
From Monday, Nov. 16, through Friday, Nov. 21, alternating lane closures may occur on Artcraft Road in both directions between the New Mexico state line and Doniphan Drive.
Additional restrictions include:
- North Desert Boulevard, between Helen of Troy Drive and the Cheddar's restaurant.
- South Desert Boulevard, between Charlie Clark Nissan and Blue Sky Drive.
- I-10 eastbound and westbound, between Redd Road and Transmountain.
Closures are scheduled 9 a.m. to 4 p.m., as needed.
Crews are working on lighting, retaining walls and bridge support structures.
Doniphan Drive
A right-lane closure will affect southbound Doniphan Drive between Tarango Street and Rio Valley Estates, from 9 a.m. to 4 p.m.
Crews will work on sidewalks and ADA-accessible ramps.
I-10 at Redd Road
The eastbound I-10 exit ramp at Redd Road will be fully closed from Monday, Nov. 16, through Friday, Nov. 20, between 9 a.m. and 4 p.m.
Crews will perform formwork for bridge support structures.
US 54 and Mesquite Hills
From Monday, Nov. 16, through Friday, Nov. 20, alternating lane closures are scheduled on US 54 in both directions between Mesquite Hills and McCombs, daily from 6 a.m. to 6 p.m.
Mesquite Hills will be reduced to one lane between US 54 and Red Man Drive, with flaggers directing traffic as needed for construction vehicles.
Additional flagging operations are scheduled from 7 a.m. to 5 p.m. at McCombs and Stan Roberts.
Crews are performing bridge work and transporting earth embankment for the Borderland Expressway project.
Coming Next Weekend: I-10 Eastbound Closure
A 51-hour full closure of eastbound I-10 between Anthony and Transmountain is scheduled from 3 a.m. Saturday, Nov. 21, through 6 a.m. Monday, Nov. 23.
Crews will perform bridge deck placement as part of the I-10 Widening West project.
Motorists traveling toward El Paso should plan alternate routes and allow additional travel time.
White Sands Missile Range
Drivers who may be affected by White Sands Missile Range road closures can call 575-678-1178 or 575-678-2222 for current closure information.
Construction schedules and traffic restrictions are subject to change without notice. Double fines for speeding in work zones may be in effect.



You must be logged in to post a comment.